New

GANTRY HEAVY

  • ✓ Boring headstock, 160 mm spindle — The Gantry Heavy carries a boring headstock with the same 160 mm spindle used on FERMAT's floor-type horizontal boring mills.
  • ✓ 1 000 mm spindle extension in W — The spindle extends 1 000 mm in the W axis, reaching into the workpiece without repositioning the gantry.
  • ✓ 10 000-50 000 mm column travel — Columns cross up to 50 000 mm in X and the headstock covers 6 100 mm in Y, so one machine spans a long line of parts.
  • ✓ 4 000 mm floor plates — Workpieces are mounted on 4 000 mm-wide floor plates, machined from multiple sides in one setup.

Technical parameters

Units
Parameter Units mm
Spindle diameter mm 160
Spindle taper ISO 50 / BT 50 / CAT 50 — optional BIG Plus, HSK 100A
Spindle speed (max.) rpm 2500
Max. Power Heidenhain or SIEMENS CNC (S1/S6) kW 74/91
Max. Torque Heidenhain or SIEMENS CNC (S1/S6) Nm 3 349/4 120
X-axis travel of Columns mm 10 000 - 50 000
Y-axis travel of Headstock mm 6 100
Z-axis travel of Ram mm 1 500
Floor plate width mm 4 000
Rapid Feed X, Y, Z mm/min. 20 000 / 20 000 / 10 000

Imperial values are shown where an exact equivalent exists. Parameters without one — spindle taper, power, torque and speeds — keep their original value.

Description

The Gantry Heavy is FERMAT's boring-headstock gantry machine, built to machine large workpieces from multiple sides in a single setup instead of moving the part between machines. The same 160 mm spindle used on FERMAT's floor-type boring mills extends 1 000 mm in the W axis, and the ram travels up to 1 500 mm in Z while the columns cross 10 000-50 000 mm in X and the headstock covers 6 100 mm in Y. Workpieces are set on 4 000 mm-wide floor plates, with a wide range of optional milling heads and accessories.

Photos

01 / 03
GANTRY HEAVY

Request an offer

Tell us about your machine and we'll take it from there.